Vladivostok Linux User Group

Код: Выделить всё

# I2C module options
alias char-major-89 i2c-dev

Код: Выделить всё

--- sensors.conf.orig	2005-10-03 03:38:49.000000000 +1100
+++ sensors.conf	2006-06-18 23:13:52.000000000 +1100
@@ -1504,7 +1504,7 @@
 
 # Voltage monitors as advised in the It8705 data sheet
 
-    label in0 "VCore 1"
+    label in0 "VCore"
     label in1 "VCore 2"
     label in2 "+3.3V"
     label in3 "+5V"
@@ -1517,6 +1517,11 @@
     # vid is not monitored by IT8705F
     # comment out if you have IT8712
     ignore  vid
+    ignore in1
+    ignore in5
+    ignore in6
+    ignore in7
+    ignore in8
 
 # Incubus Saturnus reports that the IT87 chip on Asus A7V8X-X seems
 # to report the VCORE voltage approximately 0.05V higher than the board's
@@ -1524,10 +1529,11 @@
 # the next line should bring the readings in line with the BIOS' ones in
 # this case.
 # compute in0 -0.05+@ , @+0.05
+compute in0 0.03+@ , @-0.03
 
 # If 3.3V reads 2X too high (Soyo Dragon and Asus A7V8X-X, for example),
 # comment out following line.
-    compute in2   2*@ , @/2
+    #compute in2   2*@ , @/2
 #
     compute in3 ((6.8/10)+1)*@ ,  @/((6.8/10)+1)
     compute in4 ((30/10) +1)*@  , @/((30/10) +1)
@@ -1560,6 +1566,8 @@
 
     set in0_min 1.5 * 0.95
     set in0_max 1.5 * 1.05
+    #set in0_min 1.2
+    #set in0_max 1.8
     set in1_min 2.4
     set in1_max 2.6
     set in2_min 3.3 * 0.95
@@ -1591,12 +1599,14 @@
 # (see ignore statement right below).
 
     label temp1       "M/B Temp"
-    set   temp1_over  40
+    #set   temp1_over  40
+    set   temp1_over  45
     set   temp1_low   15
     label temp2       "CPU Temp"
-    set   temp2_over  45
+    #set   temp2_over  45
+    set   temp2_over  50
     set   temp2_low   15
-#   ignore temp3
+    ignore temp3
     label temp3       "Temp3"
     set   temp3_over  45
     set   temp3_low   15
@@ -1618,6 +1628,9 @@
     set fan2_min 3000
 #   ignore fan3
     set fan3_min 3000
+    label fan1 "CPU fan"
+    label fan2 "CHA fan"
+    label fan3 "CHIP fan"
 
 # The following is for the Inside Technologies 786LCD which uses either a
 # IT8705F or a SIS950 for monitoring with the SIS630.