Код: Выделить всё
ETHERNET DEVICES
Different drivers make use of different parameters, but they all at least share
having an IRQ, an I/O port base value, and a name. In its most generic form, it
looks something like this:
ether=irq,iobase[,param_1[,...param_8]],name
The first non-numeric argument is taken as the name. The param_n values (if
applicable) usually have different meanings for each different card/driver. Typ-
ical param_n values are used to specify things like shared memory address, inter-
face selection, DMA channel and the like.
The most common use of this parameter is to force probing for a second ethercard,
as the default is to only probe for one. This can be accomplished with a simple:
ether=0,0,eth1
Note that the values of zero for the IRQ and I/O base in the above example tell
the driver(s) to autoprobe.
The Ethernet-HowTo has extensive documentation on using multiple cards and on the
card/driver specific implementation of the param_n values where used. Interested
readers should refer to the section in that document on their particular card.Код: Выделить всё
# PCI device 0x10ec:0x8139 (8139too)
SUBSYSTEM=="net", DRIVERS=="?*", ATTRS{address}=="00:e0:4c:eb:07:53", NAME="eth0"
# PCI device 0x10de:0x0057 (forcedeth)
SUBSYSTEM=="net", DRIVERS=="?*", ATTRS{address}=="00:13:d4:f9:ca:82", NAME="eth1"
# Firewire device 0011d800006c9193)
SUBSYSTEM=="net", DRIVERS=="?*", ATTRS{address}=="00:11:d8:00:00:6c:91:93", NAME="eth2"/etc/modprobe.conf решение хорошее, но только не в случае, когда драйвера вкомпилены в ядро.